Huawei Nova 9 is a new mid-range smartphone that has quad rear cameras and is powered by Qualcomm Snapdragon 778G SoC. The device comes out of the box with EMUI 12 update. In this tutorial, you will find the Huawei Nova 9 (NAM-LX9) testpoint, which will be helpful in your future reference to remove the Huawei ID, remove FRP, User Lock, and firmware flashing. Then follow this article.

Why Do We Need TestPoint?

  • Install the firmware file on Huawei Nova 9.
  • You can remove Huawei ID using Test Point.
  • Repair IMEI and NVRAM using it
  • Restore or Unbrick dead Huawei Nova 9 by flashing firmware.
  • Easy to remove FRP lock or screen lock

Where to Find Test Point in Huawei Nova 9

  • First, Download and Install Huawei USB Drivers on Windows PC.
  • Remove the back panel of the Huawei Nova 9 device carefully. Try not to damage hardware parts.
  • Now, check the screenshot below to find out the Huawei Nova 9 Test Points.

Also Read

How to Install Google Play Store or GMS on Huawei Nova 9, Nova 8, and Nova 8i

How to Remove Huawei ID on Huawei Nova 9 NAM-LX9 FRP Lock

  • Download and install the SigmaKey Software on your computer.
  • Connect your device to PC using a USB Cable in upgrade mode
  • Select the Serial Port as DBA Adaptor Port.
  • Select the Software Testpoint On Off
  • Now load the downloaded firmware package “UPDATE.APP”
  • The software will start the flashing process. Wait for a few seconds or minutes to complete the process on your Huawei Nova 9. Do not remove your device.
  • After the process, the device will enter factory mode.
  • Now you can connect your device again by removing and connecting the USB cable again.
  • Now under serial port, make sure you select USB (autodetect)
  • Select Authorize has Huawei
  • Tap on Remove Huawei ID.
  • The process will begin to remove the firmware protection, also called FRP lock.
  • After successfully removing the Huawei ID, you must set the testpoint OFF. This will again revive the phone from factory mode to normal phone mode.
  • Select the Serial Port as USB (autodetect), Authorize with device model, and then tap the Software Testpoint on/off.
  • After completing the process, your device will be back to normal

That’s it, guys. We hope this guide was helpful to you. For additional queries, you can comment below.